Charger Forums banner
Cancel

Part # and offset for super 44 flowmaster for 3.5L

Jump to Latest Follow
1 - 1 of 1 Posts
MooseOffTheWall

·
Registered
Joined
·
840 Posts
Discussion Starter · #1 ·
Does anyone know the part # for the flowmaster super 44 mufflers for the 3.5l? I was told the inlet/outlet diameter to get is 2.25. I need the offset :( I am using the stock piping.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
0 Replies
1 Participant
Last post:
MooseOffTheWall
Charger Forums
ChargerForums to connect with the Dodge Charger community to discuss SRT, Hellcat models, maintenance, mods and more.
Full Forum Listing
Explore Our Forums
General Charger Discussion Performance Discussion/Modifications Exterior Discussion/Modifications Charger SRT-8 Discussion Charger Problems/Assistance
Recommended Communities
Community avatar for LX Forums
LX Forums
268K+ members
Community avatar for Dodge Charger Forum
Dodge Charger Forum
44K+ members
Community avatar for The Toyota Crown
The Toyota Crown
NEW!
10+ members
Top