[WestCoastDan]

very subtle, possibly why Dodge didn't bother but I like it so far.

Too bad the dash alignment is so far off above the headlight switch.

The picture makes the ashtray not quite match. In daylight, it is much closer to the factory silver radio bezel.

I'm thinking shifter plate next, we'll see if it looks OK or not.

The strips are milled aluminum sheeting that I cut on the CNC.

The ashtray and surround are wrapped in vinyl. It has a couple of problem spots that a second attempt should eliminate, but overall I like it.
+++

 

[teez52]

Looks good, but for the shifter plate you might want to check into BT's shifter plates as they are perfect. Then again if you have access to a CNC you can make them perfect (and cheaper) as well as long as you measure properly.

 

[Phanta5m]

creative... I like it:bigthumb:

in the first pic... i was thinking of putting a custom dash tag from BT... it would have to be sized smaller than the regular ones though

 

[Waldo]

I like it...the first pic looks a lil crooked tho.

 

[WestCoastDan]

The gauge pod and the dash pad do not line up well as one might expect.
This is probably the reason there was no trim piece there from the factory.
+++