NEED HELP, rims

The rim shop told me that any higher than 20 offset would make the tires stick out way too much

Click to expand...

You mean they told you lower than 20, right?

It might be the other way around im not sure

Click to expand...

As I recall you asked this forum for advice. The people here are quite knowledgeable when it comes to technical issues. Ignore at your own peril.

Well, you're clearly not looking at a perfect fitment with wheels that have a 35mm offset. It might be made to work, but spacers will be required. Also, didn't you say the Vossen's have a 5x120 bolt pattern? That will have to be modified. My recommendation would be to pass on these and look elsewhere.

As I indicated in an earlier post, the "best" offset depends on the wheel/tire width. Without knowing that, its difficult to give you a meaningful answer.

I'm running 20x8 with a + 20 offset on a 09 R/T RWD.

I am barely clearing the nut on top of the knuckle with this setup so I would say if your going to run anything wider than 8 inches wide you will need a significantly more offset or a nice spacer.

Click to expand...

I don't think this is necessarily the case. I am running 20x9 (245/45 tires) with 20mm ET and they fit fine.

Interference with the upper control arm/knuckle bolt is more a function of tire diameter.

It might be a good idea to start a new thread. More details about your Charger (RWD? AWD?) would also be helpful.