Charger Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
815 Posts
Discussion Starter · #1 ·
Hey everyone! It's been a while since I have been on the forums. I lost interest in my car for a while, but am slowly starting to get back into it. The mod bug is starting to bite again, and I am looking at a set of cutouts. My car is dropped on KWV2 coilovers, and I was wondering if the low-pro cutouts hang any lower than the stock components underneath the car. I scrape my cats occasionally but never really bad. So to all the lowered LXs with cutouts, how are the cutouts holding up and have you had any scraping problems any worse than you had before? Thanks for any input in advance!
 

·
Premium Member
Joined
·
5,973 Posts
From pics it looks like tgey are a good 2 inches lower than the stock piping.
 

·
Registered
Joined
·
815 Posts
Discussion Starter · #3 ·
Ughhhh don't think I can afford to lose 2 more inches of clearance
 

·
Premium Member
Joined
·
5,973 Posts
You might be able to place them higher up let me look at a few more pics and see if I can cone up with a good idea.
 

·
Premium Member
Joined
·
5,973 Posts
Their is a "shield" thing on the cutouts than angles them down but if you get rid of it you might be able to angle them up toward the car and save an inch.
 

·
Registered
Joined
·
4,467 Posts
Check with AreTee. He's on V2's as well and I know he has cutouts, just can't remember which ones.
 
1 - 6 of 6 Posts
Top