Charger Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have 2013 Dodge Charger Sxt Plus. Makes a Beeping/Elextrical Noise Behind Glove Box. Can't seem to figure out What's Casuing Noise.
It will make noise when car is on and/or Off.
No Troubles Pop up when doing a diagnosis test. Car runs, starts, drives fine. All bells and whistles work.
Not sure what's causing beeping noise. Only last 15 seconds and stops.
Any help or suggestions is appreciated!:)
 

·
Registered
Joined
·
2,596 Posts
It could be the actuator for the passenger blend-air door or the recirculation door. After a certain number of ignition cycles, the HVAC system will automatically run a Actuator Calibration 10 minutes after turning the ignition off. This is why you can hear the clicking when the car is turned Off. Actuator Calibration also runs when turning the ignition On after reconnecting the car's main battery.
To check for HVAC codes (Bxxxx body codes) you need to use a scanner that can read all codes (not just Pxxxx powertrain codes). There are Bxxxx codes for the blend-air door and recirculation door actuators.
.
 
  • Like
Reactions: DodgeCharger13

·
Registered
Joined
·
1,790 Posts
Have you looked at whats in the glove box itself? If it not just the blend doors cycling.
 
1 - 4 of 4 Posts
Top