Charger Forums banner
throttle body
1-11 of 11 Results
  1. SRT Engineering Q&A Area
    I have 2013 v6 I've had issues today I wasnt paying attention to my gas( I had a rough day ) so I ened up running it out gas tried cranking to verify and sure enough I did ( at this point it everything was hitting just not fire all the way as would if out gas)so I put few gallons gas from gas...
  2. Charger Problems/Assistance
    Hello guys! I own a 2010 Dodge Charger (V6). About 9-10 months ago, out of nowhere, my car started to vibrate at a very specific speed, 45-50mph. It would happen randomly, and it would only happen when I slowly pressed the gas pedal (but not all way). It should also be noted that if I ever fully...
  3. General Charger Discussion
    Hi everyone. I recently installed the 392 intake manifold onto my 5.7 hemi. The 5.7 throttle body bolted right up, but I am noticing a sound that I didn't notice before when putting the car into "run" mode before starting it. I've made sure that the throttle body isn't hitting anything when it...
  4. Performance Discussion/Modifications
    Hey, just signed up for the forum, and had a quick question. If this isn’t the place to ask, I apologize and will delete if needed. My question is I’m wanting to upgrade to a Fastman TB but, not sure which one would be the best application for my car. 19’ SP with cat back exhaust, HC intake box...
  5. Performance Discussion/Modifications
    I have an 06 Charger RT 5.7 that I'm wanting to start upgrading. I don't know a lot about these cars because my last project was a 78 Z28. My plan right now is to start simple and get a tuner, CAI, throttle body, intake manifold, and replace the full exhaust. Later I'll probably do the heads and...
  6. Performance Discussion/Modifications (2011 +)
    I have a new Charger it now has 8,000 miles on it. I have changed the intake system to an Airaid CAI. I have tried to get a better response from the pedal than it has. I tried a Pedal Commander and it isn't giving me what I,m looking for. I want to change my throttle body and while I have it...
  7. Charger Problems/Assistance
    Hello! I have a 2009 Dodge Charger RWD 69K miles - Currently living in Northern NY- AKA pot holes the size of Connecticut central. I am having a front end suspension noise that is driving me to the point where I am about to drive this thing off a bridge....I mean...continue trying to fix it...
  8. Performance Discussion/Modifications
    All right, my setup so far is flowmaster duel cat back, K&N intake and 91oct diablo tune ... With that being said... I have been looking for some good headers, with an equally good price, which has been hard to find. I found the MotoBlue Long tube headers, but have read some back and forth...
  9. Charger Problems/Assistance
    My 06 r/t was stalling and cutting off, I tried the key dance and came out with codes p1521 and p2110 first. Had oil change and throttle body cleaned and right after that. Car started almost right up, rough idle first and then it finally calmed down after a few mins. Drove the car and the mil...
  10. V6 Specific Discussion
    I recorded a new video of my 2005 Magnum SXT with the Inertia V1.1 Camshafts, Ported & polished manifold, ported & polished 74mm throttle body and custom tuned by Mike Lafrad. Bolt-ons include AirHammer HO intake, Blastin Bobs 10db kit (replaced suitcase w/ dynomax muffler), and airflow mods...
  11. V6 Specific Discussion
    Porting the 3.5L V6 Throttle Body I started this project last week and got quite a bit of questions and lots of inquiring minds so here is my best shot at explaining the porting of the V6 throttle body. The Intake Diameter at the entrance of the Upper Intake Plenum is exactly 72mm. For the...
1-11 of 11 Results
Top