Charger Forums banner

Search results

1-15 of 15 Results
Advanced Search
  1. exhaust questions

    V6 Specific Discussion
    The longer the quieter, 18" would be the longest that would work. They sound nearly the same as their mufflers. I would use a 2 1/2" and not a 2 1/4". If you left the resonator on and only changed the muffler I do not think you'll get drone.
  2. Successful "Tuna Boat" Mod complete!

    Performance Discussion/Modifications
    What month was your 06 built? I see yours had the thin edge tips which will have the straight thru front suitcase, thus the drone.
  3. 2012 srt8

    Charger SRT-8 Discussion
  4. Blastin Bob MF-V6-Y

    V6 Specific Discussion
    You can see if high888 can answer questions about the sound.
  5. 225ssr-v6-y
    You're welcome. My vendor support will expire before then and I'm not going to renew, not to worry the website will still be there. Bob
  6. 225ssr-v6-y
    The spot where it need to be cut is easy to get to with a hacksaw. DIY no problem on a Charger. They take me about 15 minutes or less. Bob
  7. Mandrel Bends on Blastin Bob Setup! Is It Worth The Extra $45?

    Performance Discussion/Modifications
    On the 6 the advantage will be very slight, if any. The two press bent pipes divide from one single pipe, so your single 2 1/2 , or 2 1/4" depending on the size of your six, would have to have over twice the volume of two 2 1/4" press bent pipes to be beneficial, but there is no doubt that...
  8. Muffler shop said they have a muffler "the same" as Flowmaster 40

    Performance Discussion/Modifications
    You may be okay but the longer tips are going to add to the sound. It shouldn't drone too bad.
  9. 7db 250X4 in stock!!
    I received a small amount of 4" resonated tips for the 7db 5.7L kits. There will not be another shipment until next year, so don't wait if you wait them before x-mas. Bob
  10. Mandrel kits are now available
    FYI, for those who are not aware. All my exhaust kits, V-6 & V-8, are now available with mandrel bends. Just check out the website Blastin'
  11. E-cutouts installation

    Performance Discussion/Modifications
    I use a plasma cutter.
  12. exhaust setup

    Performance Discussion/Modifications
    Correct, if there was a mandrel in the core when it was bent to an "S" shape it would not collapse. I believe that a mandrel would get pretty beat up since magnaflow perforations go from end to end in the core and the stock suitcase has perforations only in the center part of the core...
  13. My sound clip library
    Here is a link to all the sound clips I have gathered of my kits.
  14. Welcome to !
    Yes, any of the dual kits I sell will make it louder, even the magnaflow kit. The 2.7 is slightly louder then the 3.5 and if you split the exhaust with no resonators it will resonate inside. I have sold my Y pipe and a pair of used hemi resonators a couple of times. This setup is very quiet...
  15. Newbie vendor

    New Member Introductions
    Good morning, has just signed on as a supporting vendor. I have already received a ton of support over the last few years from many current and past members and it has been very much appreciated. I look forward to helping with your exhaust needs or questions any way possible...
1-15 of 15 Results