Originally Posted by phillyphill39
argh im still having trouble with this. why couldnt they just put fold down seats in all of the cars.
Here's the details, see the attached picture and refer to these steps:
Step #1: On each corner of the rear lower seat
, pull up hard, until you hear it pop out of the car floor (it has metal loops that "plug" into the floor) - then remove
the lower seat
so that you can get to the "nuts" in step #2.
Step #2: loosen the "nuts" on Bolt #1 and Bolt #2 enough so that the seat
can be tilted forward when you push down the Metal spring clips in Step #3.
Step #3: Push down Spring clip # 1, by sliding a long flat-head screw driver between the rear upper seat
and the trunk wall (it takes some Trial and error), until you feel the metal spring clip go down - then tilt/pull that part of the seat
forward - insert something between the trunk wall and the upper rear seat
, to keep it from popping back in. Then do the same for Spring Clip #2.
Step #4: Then, once you are sure that the spring clips are dis-enganged, lift the upper rear seat
(part) up, out and then tilt down. You can't go to far with it because of the attached seat
.... And that is it