Switches Added

[#18Daytona]

I added a few switches, I didn't want to drill any holes. I removed the rubber storage insert, and applied a metal plate. The switches will be for my halos, led lights behind the grill, and the last for something in the future. Thought about painting the plate sublime instead of a brushed metal look. Still have to do the wiring, didn't have an idea where else to put the switches.
http://i174.photobucket.com/albums/w98/Sublime0018/07Charger001.jpg
http://i174.photobucket.com/albums/w98/Sublime0018/07Charger002.jpg

[chasercharger]

Holy crap dude, that's incredibly clean my man. Nice work!! And great placement. I vote not to paint it, love the bare metal look. It may look a little cheesy and overkill if painted.......
Chase

[TORREDAYTONA]

i like your car but sorry i dont like this mod, looks clean though

[Spankis]

I like it, if you had access or could get it done cheap, a bead rolled around the edge would make it look very nicely finished!

[#18Daytona]

Hey Chase & Spankis thanks for the feedback.

[SVRSRTCDN]

Nice idea but do it again, get better looking switch gear, drill the holes in a straight line next time too.
The way it looks now looks like something off a weekend junker race car you see at the local track. Sorry

Idea is great, but just needs a better touch.

[Crow]

A sublime pin stripe border about a half inch in from the edges might look good. Also, the radius on the corners need to be done better. No gaps........

[HedleyLamarr]

along the lines of the "better looking switch gear" that SVRSRTCDN mentions, whynot try to find some light-up on/off buttons instead? You could get them in a green hue and keep with the Sublime theme while leaving the brushed metal plate.

[T-Rex]

#18 - I had the same setup for my nitrous switches, (except I attached the metal to the rubber cubby bin). Top to bottom - Nitrous Arming, Remote Bottle Opener, Bottle Heater, ESP Switch.

http://i148.photobucket.com/albums/s20/troyriedel/Car%20Stuff/zex9.jpg

I like the "tucked away" look better so here is what I did: Cup holder switches and moved ESP switch to console bin:
http://i148.photobucket.com/albums/s20/troyriedel/Car%20Stuff/switch2.jpg
http://i148.photobucket.com/albums/s20/troyriedel/Car%20Stuff/switch3.jpg

I have a new console bin on the way to replace the one I modded.

[goval]

Nice set-up! IMHO, I think te polished plate doesn't fit well with the chrome trims from the shifter. I would get a chrome plate to replace the polished one. And don't paint.

[MCO_Carter]

I dig it....I'd thought about doing something like this myself for the ESP mod, but I use that bin for my celly.

[juvezak]

looks like someone is gonna take off at the dragway lol very nice man :)

[ping]

I dig it completely, definitely looks factory. Keep it unpainted, matches the trim around the shifter.