Just got my honeycomb grille inserts

[Kmac1044]

I got it home and popped the hood but dont know where to go now. Has anyone installed this themselves? It would be very helpful to find a write-up, something like the blinker mod write-up that was a piece of cake.

[Hemi4E]

http://www.chargerforums.com/forums/showthread.php?t=18203

or

http://www.chargerforums.com/forums/showthread.php?t=14944


Search for "honeycomb" and you'll find quite a few useful threads!

[hades]

got this from CPCMAILMAN

You do not have to followthe Mopar instructions. You can remove the grill assembly through the hole the grill fills.

1. remove the two plastic pieces that are on top of the hole between the rad and the front of the car. They have three clips each.
2. Look at the back of the middle section of the crosshair grill and you will see two screws. Remove the two screws. Examine the screws to see which type of screwdriver would be most appropriate. There are two more screws at the ends of the horizontal part of the crosshair grill, one at each end. You will need something like a thumbnail ratchet to remove these screws as there is very little room. Look at number 13 of the Mopar instructions for the location of all four screws. The end screws are hard to reach but it can be done if you persevere.
3. The grill is now held in by four plastic clips, two at the bottom of the grill and two at the top. These clips are about two inches long each, and can be popped off, two down and two up. You will hear them pop. I used a screwdriver. The grill will now come right out, and you can replace the insert and put the grill back the same way. Goodluck.

[Kmac1044]

DAMN that was quick response time. Thanks fellas

[cjsCharger]

Sounds easy! I had to remove the whole front bumper fascia to put my billet grill in, took me about 1 1/2 hours.

[navycharger]

when i did my daytona grill we just pulled those fours screws out and it is way easier then taking the whole front fascia off, you will just need a really stubby philips screwdriver to get the side screws out..... shouldnt take more than 20 minutes or so if you have to right tools, good luck

[mywhitecharger]

http://www.chargerforums.com/forums/showthread.php?t=18203

or

http://www.chargerforums.com/forums/showthread.php?t=14944


Search for "honeycomb" and you'll find quite a few useful threads!



what she said.


Also - Don't remove the whole front clip it'll take you all day.