Frustration at Stock BA Amp and Speakers

[Virginia_Dodge]

I am trying to hook up a nice set of Diamond Audio Component speakers to the fronts. I hooked up my crossover and I have woofer sounds, no highs really and the tweets doesn't produce sound.

Does the stock BA system already cross the Highs to go to the in-Dash speakers and do something to the doors? I spent 3 hours fabricating the speaker mount and hooking it up and wasted my day, I put the stock BA speaker back in.

:confused::confused::confused::confused::confused: :confused:

[727ChargerKid]

I am trying to hook up a nice set of Diamond Audio Component speakers to the fronts. I hooked up my crossover and I have woofer sounds, no highs really and the tweets doesn't produce sound.

Does the stock BA system already cross the Highs to go to the in-Dash speakers and do something to the doors? I spent 3 hours fabricating the speaker mount and hooking it up and wasted my day, I put the stock BA speaker back in.

:confused::confused::confused::confused::confused: :confused:

I did the same thing with my first setup...if your going to use a high level signal like that your going to have to tap into the dash speakers...i just pulled them up and tapped into the wires on each side...a much better solution that costs a little is the peripheral chyaa interface which gives you front and rear rca outputs and works in conjunction with the factory BA amp i got mine for somethin like $80 or so

[Virginia_Dodge]

my components run off speaker level outputs. Diam D6 series, the Woofer and tweets connect to the Crossover at speaker level. not a crossover like a passive one under the HU.

[727ChargerKid]

my components run off speaker level outputs. Diam D6 series, the Woofer and tweets connect to the Crossover at speaker level. not a crossover like a passive one under the HU.

All component sets connect to the crossover at speaker level thats a passive network...the signal should be coming from an amp tho...and i hope your not trying to use the factory one...you need to get that chyaa interface and plug that into your amp then hook that up to your x-over